Other than the temp gauge the dash looks quite nice
With a new Temp Gauge, Dash Light, Ignition, Push to Start Switch,
Light Switch and Power Director Pressure Indicator
The lights needed some TLC after years of service
Bead blasted and painted inside and out keeping the ground connections clean
With new wires threaded into place they are ready for night work
We'll have to find a factory cast piece for under the right side light
The work light had a replacement sealed beam without the hole for a red light behind
I had a good one from an unusable housing
It is ready except for the red bulb and special socket
I soldered a bronze strap to a new socket and shaped it to hold the red LED
iBrightstar 9-30V Extremely Bright 1156 LED replacement
The sealed beam is an original and shines bright
The red LED is nice and bright - only red to the eye but saturates the photo a bit
The replacement switch looks original too
The replacement cast piece painted and installed completes the wiring
